IN3268 Bottom Board Default

LED

COIL

J10

J11

J12

J13

To allow a loop-output, the J2, J3 and J4 pins must be open on both the top and the bottom boards. Again, the outputs will be overdriven if there is no local monitor connected to the input when the termination is disabled. This may cause serious problems to the display device.

Warning: Jumpers should only be adjusted by qualified technicians! An improper setting may lead to incorrect operation and could even result in severe damage to the computer video port or the monitor.

IN3264 / IN3268 OPERATION MANUAL - REV 1.3 01/04/01