Step 9.
Assemble the toys on the tray as shown. The mirror, squeaker, and music button are already assembled.
Mirror and music button— DO NOT allow liquids around music button.
Insert teether stalk into the tray.
Squeaker
(Note: Squeaker
will not work in storage position.)
NOTE: Toys may be removed from tray for cleaning or storage.
Retaining
loops
Insert
this end first
Push beads firmly over the retaining loops on bead bar. Insert end with loops into the hole directly over leg, and turn bar until fully seated (retaining loops do not go into the hole). Then plug forked end of bar into the square hole in the tray.
Push wheel cap onto steering wheel, then push assembly into large hole in tray.
Tighten screw until clicker does not move
Push end of phone cord through hole in tray, then tie a knot under the tray. Pull on phone to make sure cord is secure.
To Use the Seat Lock
Push gently on latch and turn the seat until latch engages in one of the four stop positions.
To allow seat to swivel again, pull lock out.
7
To Adjust the Seat Height
Do not adjust height while child is in activity center.
Step 1.
Press in the buttons on each leg to adjust seat to desired height. The bottom edge of the upper tubes must be even with one of the three lines on the lower leg tube.
For your child’s safety, all three legs must be set to the same height. Tray must be level.
8