To Adjust the Seat Height
Do not adjust height while child is in activity center.
Step 1.
Press in the buttons on each leg to adjust seat to desired height.
For your child’s safety, all three legs must be set to the same height. Tray must be level.
Step 2.
After adjusting height of the seat, CHECK that your child’s feet can rest completely on the floor of your activity center. Tray should not be too high or too low. Remove child and readjust height if necessary.
Tray at proper height
TRAY TOO HIGH | TRAY TOO LOW |
To Convert Your Convertible Entertainer® for Toddler Use
When your child is able to walk, you can convert your Entertainer® into the toddler mode. This open tray arrangement, along with changing the toys to allow new
Step 2.
Turn house/mirror toy so that rib on base of house (see closeup) lines up with arrow on tray. Lift house to remove.
Step 3.
Unscrew the three large plastic bolts attaching tray to legs. Do not try to pull bolts out of tray.
Remove tray from legs.
Step 4.
Underneath tray, pull back finger latch where the two halves of tray meet. While holding latch, lift right side of tray up to release it from left half. Pull tray open.
Lift
Step 5.
For each leg: (1) push and hold in the leg button; (2) push leg down to the lowest position. (Top of inner leg section must be slightly below top edge of outer leg.)
Tipping or fall hazard. Do not use in toddler mode unless legs are set to lowest position.
2. Push | Legs must be | |
down | ||
at this height! | ||
|
1. Push in
activities, can give your child a whole new play experience.
A. Change base and tray
Step 1.
From top of seat, reach through the leg openings as shown and pull plastic tabs (also found at back and front
Step 6.
Place open tray over base so
Graco® name is seen through opening in trays as shown. Align bolts over holes in legs.
Starting with bolt under the house, partially tighten all bolts (to allow alignment), then fully tighten.
Partially tighten
this bolt first
of seat) slightly inward while lifting seat to remove.
9 |
Be sure bolts are tight. Pull up tray at each bolt to make sure it is attached to leg.
10