Battery Installation
Parent Unit
•The battery must be plugged into the Parent Unit before the
unit will be ready for use. Remove the battery door cover on the Parent Unit with a key or flat blade screw driver. Remove the battery pack from the packaging and plug into the back of the unit. Place the battery pack into the recess and press the wire into the slot on the side. Replace the battery door.
Nursery Unit
•Turn the unit over, and use screw driver to remove the battery door.
•Place
•Place the battery door back on the unit and fasten the screw.
•Please remove a dead battery promptly. A dead battery left in the unit may leak, damaging your unit.
•Do not attempt to recharge a
•A rechargeable battery CANNOT be recharged by plugging the AC adapter into the Nursery Unit.
•Remove the batteries from the unit if it is no longer being used or will be stored for an extended period of time.
Plug in cord
|
|
|
|
|
|
|
|
|
|
|
| - |
| + | - |
|
| ||||
| + | - |
| + |
| |||||
|
|
|
|
|
|
|
|
|
|
|
Batteries should be disposed of properly by recycling.
Using AC Adapters
•The Parent Unit can use either the rechargeable battery that comes with the unit or standard 120 volt AC household current. The Nursery Unit uses
•To use AC adapters, plug the connector on the cord into the AC adapter jack on the side of the Parent Unit (under the
rubber cover) or the back of the Nursery Unit. If using the Docking Station, plug the AC adapter connector into the back of the Docking Station. The Parent Unit may now be placed in the Docking Station. Then plug the adapter into a standard wall out- let.
•Use ONLY the Graco adapters included with the unit. Do not use these adapters with other equipment under any circumstances.
•If units do not work, check that AC adapters are plugged into working outlets.
•When electricity is off (from a power failure, etc.), the Nursery Unit will operate on
Selecting Channels
•In case you are experiencing some interference, the channel on the Nursery Unit can be changed by pressing the Channel Button (labelled “ch”) on the side of the unit. The Parent Unit will automatically scan all of the available channels until it locks on to the Nursery Unit. If you are still experiencing interference, press the Channel Button on the side of the Nursery Unit up to 3 times until a good channel is found.
3