Regalo Safety Gate installation instructions Step

Page 5

Gate Instructions

Step 4.

Important: Keep these instructions for future reference

You are now ready to install your gate in the doorway. Begin by positioning your gate level and centered in the doorway opening. Pull the 4 Threaded Spindle Rods out of the ends of the frame Tubes until the Flat Plastic End touches the wall. **If you are using the Wall Cups then the flat plastic ends of the Threaded Spindle Rods should go into the Wall Cups that are fastened to your wall. Next, while holding the flat plastic ends of the Threaded Spindle Rods against the wall, turn the Adjustment Wheels counter -clockwise until the Adjustment Wheels are up against the ends of the frame tubes as shown in Diagram D. DO NOT TIGHTEN. Go to Step 5 for Final Adjustment. HELPFUL HINT: It may be necessary to hold the Threaded Spindle Rod while turning the Adjustment Wheel to ensure the Threaded Spindle Rod does not turn.

Adjustment Wheel

Diagram D.

(5)

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Important Keep these instructions for future reference Item no MAX Size Assembling and Installing Your Gate Wall Cup Step Important Keep these instructions for future Diagram F Diagram G1 How to open the Gate Door Instructions for Gate Extension
Top Page Image Contents