Screw hinge spindles (I) into top and bottom rails of second section (o) until they are extended equally. These will be adjusted to correct length at a later stage so do not tighten .
Mounting Locking Side
Screws provided are for mounting directly into wood. If mounting into brick, drywall or other surfaces, use appropriate hard- ware. If installing into hardwood (i.e. oak) drilling a pilot hole may be necessary.
Hold template (b) against mounting surface in line with opposite hinges, making sure end marked “1” is even with floor.
Mark 4 screw hole positions. Remove template .
Fit a locking latch (e) into locking latch brac- ket (f) and using 2 screws, screw into lower set of screw holes.
Fit remaining locking latch (e) into remaining locking latch bracket (f).
Determine which direction gate should open.
For stairways, gate should never open out
over stairs.
As an added safety measure, a stop pin has been provided.
Using 2 wood screws,screw into upper set of screw holes .
Push bottom latch spindle (m) into lower rail of main gate section (n).
5