Cardinal Gates MG25 manual Assembly Instructions, Keep plastic shipping tabs in place Or D

MG25 DuraGate

FOR OPENINGS 26.5” (67cm) - 41.5” (105cm) • Average installed height 29.5” (75cm)

ASSEMBLY INSTRUCTIONS

A

BC

OPTION

ONE-WAY

STOP BRACKET

*

1C or D

4X

1 ” CARDINAL GATES

1.Place gate on top of carton to establish height. Use short screws (C) for doorframes or longer screws (D) into drywall to reach a stud.

D

2

F

2.Level gate by adjusting telescoping tube attached to upper gate with allen wrench (F).

F

3

F 2X

3.Loosen width adjustment set screws at top and bottom of gate with allen wrench (F) slightly to allow gate to expand.

Keep plastic shipping tabs in place.

4	A	5	A
			C or D

2X

4.Attach latch bracket (A) to latch rod with bracket snug against bottom of eye bolt. Expand gate so that latch bracket (A) is against mounting surface. Mark holes.

5.Separate bracket from rod and mount as marked. FOR ONE-WAY OPERATION: Read STEP SEVEN and install safety bracket on bottom hole.

6	7	OPTION
		ONE-WAY

STOP BRACKET

B

F

6.Use Allen wrench (F) to tighten adjustment set screws after removing plastic shipping tabs.

7.Install one-way stop bracket (B) on one side of latch if you wish to have gate open in only one direction.

GATE IS RECOMMENDED FOR CHILDREN UP TO 24 MONTHS.