AXIS T91A Series Installation Guide | Page 11 |
Install the AXIS T91A64 Corner Mount
1.Refer to Hardware overview, on page 4 for information on the supplied parts.
2.Attach the corner bracket in the desired position using screws that are appropriate for the wall material and the weight of the camera and bracket.
3.Attach the bracket holder (not included) to the corner bracket using the supplied screws.
4.The wall bracket (not included) can temporarily be hooked on the bracket holder, in order to easily route the cable through the bracket:
Bracket | Tabs |
|
holder | Wall bracket | Locking tab |
| ||
| Corner bracket |
|
Slide bracket between the | Swing wall bracket | |
tabs on the bracket holder | ||
to the side for | ||
| ||
| temporary support |
Note:
The bracket holder and wall bracket (AXIS T91A61) are required for the installation but must be purchased separately, see the table in Package contents, on page 3.
5. Route the necessary cables through the wall bracket, securing them in the cable holder.
ENGLISH
Cable Cable holder
6.Press the locking tab and unhook the wall bracket from the temporary position.
7.Use the Torx screws to secure the wall bracket to the bracket holder.
8.Refer to the Installation Guide for the network camera for instructions on how to attach the camera to the bracket.