Mattel WD465 II. Battery Installation, III. Charging the Vehicle, IV. Operation, Transmitter

II. BATTERY INSTALLATION

(Transmitter)

Requires 4 AA alkaline batteries for the transmitter, not included.

Transmitter

1.Unscrew the battery cover with a Phillips head screwdriver (not included).

2.Install 4 AA alkaline batteries with polarity (+/-) as shown inside the battery compartment.

3.Replace battery covers and tighten screws.

III.CHARGING THE VEHICLE

Your vehicle is powered by a Li-Po battery that is permanently installed. The vehicle must be charged before play. To charge, first make sure you have installed 4 AA alkaline batteries in the transmitter as shown in Section II. Then follow these easy steps.

1.Make sure the switch on both the transmitter and vehicle are in the OFF position.

2.Open door on transmitter, hold plug and pull out charger cable (See a ).

3.Connect plug to vehicle. Make sure the connection is secure (See b ).

4.To begin charging, move the switch on the transmitter from OFF to CHARGER. Both the Red and Green LEDs light up when charging (See c ).

5.The charging process takes up to 25 minutes. Green LED goes off when charging is complete.

6.When fully charged, remove the charger cable from the vehicle.

IV. OPERATION

Infra-red LED in Transmitter needs to point towards vehicle during play. If your vehicle doesn't respond when the Transmitter is activated, make sure the LEDs are pointing at the vehicle.

Bottom view

Turn vehicle and transmitter ON to play.

TIP: Always hold the plug when disconnecting. NEVER pull on the cable to disconnect; this may cause the cable to break.

a

b c Bottom view

IMPORTANT:

• Do not cover up the infra-red LEDs with your fingers.

• Works best on flat, level, hard surfaces.

• This product is not recommended for use on carpet, loose dirt or wet surfaces.

FORWARD	FORWARD LEFT Infra-redFORWARD RIGHT
	LED

REVERSE REVERSE LEFT REVERSE RIGHT