Evolution Technologies MK-261 manual Program & Bank Change Memory, Selecting a Velocity Curve

11.PROGRAM & BANK CHANGE MEMORY

You can assign a selected PROGRAM CHANGE as well as a BANK LSB and a BANK MSB to one of ten numeric keys (0- 9). Once stored, simply pressing one of the numeric keys will send the desired PROGRAM and BANK CHANGES.

11-1	Select the desired PROGRAM CHANGE, BANK LSB and MSB. Please		refer to respective chapters for
information on how to do this.
11-2	Press the MEMORY switch. The LED starts to flash.
11-3	Press the numeric key (from 0 to 9) you wish to assign the data to. The		PROGRAM and BANK CHANGE
information is stored on the selected		numeric key.

12.Selecting a VELOCITY CURVE

The VELOCITY CURVEs determine the relationship between how hard the keys are struck and the corresponding velocity that the unit transmits.

This unit allows you to select from 12 VELOCITY CURVEs.

12-1	Simultaneously press the WHEEL ASSIGN and CHANNEL switches. The LED starts to flash showing the current
number of the VELOCITY		CURVE.
12-2	Press one of the numeric keys to select a VELOCITY CURVE. The 10 key numbers correspond to the first 10
	VELOCITY CURVEs as follows:

You can also use the “+” or “-” switches to access all the VELOCITY CURVEs.
There are 3 Fixed VELOCITY CURVEs which output the following velocity values:
	Curve	Velocity
	F 0	64
	F 1	100
	F 2	127
Note: If you don’t do anything for 5 seconds the LED stops flashing and shows			the current PROGRAM CHANGE
number.

13.RESET-ALL CONTROLLERS

This function allows you to send a RESET-ALL CONTROLLERS message to connected equipment.

13-1 Press MEMORY and X’POSER switches simultaneously.

Hold the keys down for at about 2 seconds, then the reset message is sent.

14.GENERAL MIDI MODE RESET

This function allows you to send a GENERAL MIDI MODE RESET message.

14-1 Press the GM RESET key.

Hold the key down for at about 2 seconds, then the reset message is sent.

15.SPECIFICATIONS

1.Keyboard: 61 standard keys (Velocity sensitive)

2.Control: Switches: (WHEEL, CHANNEL, PROGRAM, MEMORY, X’POSER, GM RESET, VEL CURVE, BANK L, BANK M, RESET-AC, OCTAVE DOWN, OCTAVE UP, POWER ON/OFF, Numeric Keys (0-9), −, +)