Assembling Headboard and Footboard, Step

Assembling the

Headboard and Footboard

Step 1.

Legs have a small side hole near one end. For each leg, push end with side hole firmly down into a plastic foot. Side hole must be covered by foot. It may be necessary to tap foot on a hard surface to get it all the way on.

Step 2.

Assemble headboard and long legs. Push open end of one long leg onto plastic plug under “knob” on one side of headboard.

Then push leg sideways so the rectangular plug on lower side of headboard goes into hole on side of the leg.

Attach other long leg in the same way to other side of the headboard.

Assemble the footboard and short legs the same way.

Step 3.

Insert a screw into the lowest hole on each leg and into the plastic head- or footboard.

Tighten screw securely with the included hex wrench, but do not over-tighten.

Repeat for other three legs.

CHECK that all four legs are securely attached to the head- and footboards by pulling on the legs.

Assembling the Frame

Step 1.

Line up the side tubes and crossbars on the floor as shown at right. It may be helpful to brace one side tube against

a wall or stationary object. Holes in side tubes must face each other.

Step 2.

Insert ends of the crossbars into holes in the side tubes.

600-4-00 600596

Side hole

Screw

Hex

wrench

Attaching the

Headboard and Footboard

Step 1.

Begin by attaching the frame to
the footboard.	Bumps

Stand the footboard at one end of the metal frame with the Graco® name facing out and four plastic “bumps” of the foot- board facing toward the frame.

Holding the footboard upright, grasp the two side tubes as shown and lift carefully. Rest the ends of the side tubes on the footboard.

Step 2.

	Insert two T-nuts through the
	two holes in the side tubes	Bolt
	and into the footboard tube as	T-nut
	shown. Place the bolts into the	T-nut
	shown. Place the bolts into the
	holes on the outside of the
	footboard tubes and into the	Hex
	T-nuts. Tighten bolts with the	Hex
	enclosed hex wrench.	wrench
	enclosed hex wrench.

Repeat on other side of the footboard.

Step 3.

Attach the headboard in the same way. It may be attached with either side facing the bed. The toddler bed will look like illustration.

After both endboards have been attached to the frame, use the enclosed hex wrench to FIRMLY TIGHTEN all eight bolts into their T-nuts.

Attaching the Mattress Retainers

Do not use toddler bed without mattress retainers. Mattress may slide.

Step 1.

Ribs

Snap the mattress retainers onto the center of the side tubes. The ribs of each retainer should face the inside of the bed frame. Line up the holes of the mattress

retainers with the small holes in the side tubes.