Assembling Headboard and Footboard, Step

Assembling the

Headboard and Footboard

Step 1.

Legs have a small side hole near one end. For each leg, push end with side hole firmly down into a plastic foot. Side hole must be covered by foot. It may be necessary to tap foot on a hard surface to get it all the way on.

Step 2.

Assemble headboard and long legs. Push open end of one long leg onto plastic plug under “knob” on one side of headboard.

Then push leg sideways so the rectangular plug on lower side of headboard goes into hole on side of the leg.

Attach other long leg in the same way to other side of the headboard.

Assemble the footboard and short legs the same way.

Step 3.

Insert a hex head screw into lowest hole on each leg and into plastic head- or footboard.

Tighten screw securely with the included hex wrench, but do not over-tighten.

Repeat for other three legs.

CHECK that all four legs are securely attached to the head- and footboards by pulling on the legs.

Assembling the Frame

Step 1.

Line up the side tubes and crossbars on the floor as shown at right. It may be helpful to brace one side tube against a wall or stationary object. Holes in side tubes must face each other.

Step 2.

Insert ends of the crossbars into holes in the side tubes.

606-4-00 606198

Side hole

Screw

Hex

wrench

Attaching the Headboard and Footboard

Step 1.

Begin by attaching frame to the

footboard.Bumps

Stand footboard at one end of the

metal frame with Graco® name fac- ing out and four plastic “bumps” of

the footboard facing toward frame.

Holding footboard upright, grasp the two side tubes as shown and lift carefully. Rest ends of side tubes on the footboard.

	Step 2.
	Insert two T-nuts through two
	holes in side tubes and into foot-	Bolt
	board tube as shown. Place bolts	Bolt
	board tube as shown. Place bolts	T-nut
	into holes on outside of footboard	T-nut
	into holes on outside of footboard
	tubes and into T-nuts. Tighten
	bolts with enclosed hex wrench.
	Repeat on other side of footboard.	Hex
	Repeat on other side of footboard.	wrench
		wrench
	Step 3.
	Attach headboard in the same	This side
	way. The side with the deeper	This side
	way. The side with the deeper	faces bed
	recess should be facing the bed	faces bed
	recess should be facing the bed
	as shown.

After both endboards have been attached to frame, use the hex wrench to FIRMLY TIGHTEN all eight bolts into their T-nuts.

Step 4.

To create star panel, first twist glow-in-the-dark pieces off the plastic stem (immediately discard stem). From the back of the decorative panel, insert pieces by pushing firmly in the center of each one. (There are three different sizes of stars and star openings.) Check that all stars are used and no holes are left empty.

Step 5.

Hold panel in place on headboard while inserting five screws through back of headboard. (The plastic in the screw holes may need to be removed.) Tighten screws securely, but do not over-tighten.