ASSEMBLY
9 | 10 |
| Head |
SP | LP OFF | ||
| Tray |
|
|
|
| Slot | Tab |
| Rib |
| |
|
|
| |
| Frame | Tray |
|
|
|
|
M5 x 39/16" Bolt
M5 Lock Nut
Retainer
5/16" Washer
Rib
Protruding
Side
M5 Lock Nut
•Slide a retainer between the two ribs on one side of the tray, as shown.
•Fit an M5 lock nut (protruding side facing away from the retainer) into the hexagonal hole in the retainer.
•Fit a 5/16" washer onto the M5 bolt. Insert the M5 bolt through the frame, hub, tray and into the retainer. Tighten the bolt with a Phillips screwdriver. Do not
•Repeat this procedure to fasten the other side of the tray to the other frame.
•Position the head with the face upright.
•Insert and snap the tab on the head into the slot in the tray.
11
SP | LP | OFF |
|
|
|
•Insert two 5/8" screws with washer heads through the front holes in the tray and into the head. Tighten the screws with a Phillips screwdriver. Do not
•Insert two 5/8" screws with washer heads through the back holes in the tray and into the head. Tighten the screws with a Phillips