AutoTek AT3000.1 AT1000 / AT1500 2-CHANNEL Amplifier Applications, Remote TURN-ON Chassis Ground

AT1000 / AT1500 2-CHANNEL AMPLIFIER APPLICATIONS

Stereo high pass with mono low-pass in a 2 way active, or bi-amplified system

In this application we will use a 2 channel amplifier for the high frequencies, and a second one for the low frequencies, or mono sub bass. Please consult the speaker specifications to determine maximum amplifier power requirements.

Interconnect cable checklist:

Connect the inputs of the HIGHS amplifier to a Radio/CD with good quality RCA cables. Connect the LINE OUT of the HIGHS amplifier to the inputs of the BASS amplifier with a stereo RCA to RCA cable.

Mono bass woofer wiring:

Connect the mono speaker positive terminal to the LEFT +, and its negative terminal to RIGHT -.

Switch setting checklist:

-Highs amplifier: X-OVER switch in the HPF position.

-Lows amplifier: X-OVER switch in the LPF position.

Crossover frequency control checklist:

Highs amplifier:

-HI PASS: 100 Hz

-LOW PASS: N/A

Lows amplifier:

-HI PASS (Subsonic filter): 30 Hz to 50 Hz

-LOW PASS: 100 Hz

Please note that these frequency points are suggestions only. Refer to the loudspeaker manufacturer specifications and the section “Setting up systems after installation for best performance”

Level control checklist:

-Refer to the section “Setting up systems after installation for best performance”

Minimum final loudspeaker impedances:

-2-Ohms per channel stereo.

-4-Ohms mono bridged.

CAUTION: This amp is not capable of 1-Ohm wired stereo, 2 or 1-Ohm wired mono bridged. Lower then recommended impedance will damage the amp and could possibly void the warranty.

STEREO

HIGHS

SPEAKERS

FULL RANGE

STEREO LINE INPUT

LINE OUT	R	L
LINE	R	L
INPUT	HI	+ -
	I	nd + -
	PUT
	5V 0.2V	LEVEL
	0dB 12dB	BASS EQ
	60Hz 1.2KHz	HPF
	30Hz 250Hz	LPF
	FULL LPF HPF	X-OVER
	MONO STEREO	MODE

2CHANNEL

HIGHS AMPLIFIER

	-
OUTPUT	RIGHT
	+
SPEAKER	LEFT
	-
	+
FUSE
POWER INPUT	GND REM +12V

BRIDGE

POWER PROTECT

TO BATTERY +12 Volts VIA FUSE

REMOTE TURN-ON

CHASSIS GROUND

STEREO

INTERCONNECT

RCA CABLE

MONO BASS

SPEAKER

LINE OUT	R	L
LINE	R	L
INPUT	HI	+ -
	INPUT	gnd + -
	5V 0.2V	LEVEL
	0dB 12dB	BASS EQ
	60Hz 1.2KHz	HPF
	30Hz 250Hz	LPF
	FULL LPF HPF	X-OVER
	MONO STEREO	MODE

2CHANNEL SUB BASS AMPLIFIER

	-
OUTPUT	RIGHT
	+
SPEAKER	LEFT
	-
	+
FUSE
POWER INPUT	GND REM +12V

BRIDGED

POWER PROTECT

TO BATTERY +12 Volts VIA FUSE

REMOTE TURN-ON

CHASSIS GROUND

4