Samson S2000, S1500 owner manual Guided Tour Front Panel

Guided Tour - Front Panel

	5		4	1	2	3	4	5
			-20dB	OFF	ON		-20dB
-40dB	-20dB	CLIP	PROTECTION		POWER	PROTECTION	-40dB	-20dB	CLIP
S2000		-30dB	-10dB			-30dB	-10dB
1000W X2 STEREO								SAMSON
		-80dB	CHANNEL 1			CHANNEL 2	0dB
			0dB			-80dB

1:Power switch - Use this to power the S1500 / S2000 on or off.

2:Power LED - Lights whenever the S1500 / S2000 is powered on.

3:Protection LED - This goes on for approximately five seconds whenever the S1500 / S2000 is powered on and then turns off (you’ll hear a “click” when it does so). The Protection LED will also light when overheating or other severe problems occur (see page 6 in this manual for more information). It is normal for the Protection LED to fade slowly when the amp is powered off. When lit, 0 volts DC are provided to all connected speakers, thus muting them and preventing any “thump” from occurring. For a complete description of the conditions under which this light goes on, see the section entitled “The S1500 / S2000 Protection Circuitry” on page 6 of this manual.

4:Channel input level controls - These 41-position detented knobs allow you to precisely adjust the input level of the signal arriving at the rear-panel input jacks (see #7 on the following page). At their fully counterclockwise position (labeled “-80 dB”), the signal is attenuated by 80 dB (essentially completely off). At their fully clockwise position (labeled “0 dB”), the signal is at unity gain (that is, no attenuation). When 0 dBu of signal arrives at the input jacks and the Channel input level controls are set to their fully clockwise “0 dB” position, the S1500 / S2000 delivers full power output.

5:LED meters - These three-segment LED meters continuously monitor the power output level for the corresponding channel. For convenience, the segments are labeled, from left to right, -40 dB, -20 dB, and CLIP. The left (-40 dB) segment lights whenever input signal is present. The right (CLIP) segment lights whenever the channel is outputting signal at full strength. For the best signal-to-noise ratio, the right (CLIP) segment should light occasionally during peak levels; if it lights frequently, you may be overloading the S1500 / S2000 and a distorted (“clipped”) signal is probably being output. If this occurs and backing off the Input Level control delivers too low an output level for your application, consider using Bridged mode (see the “Bridged and Parallel Modes” section on page 7 in this manual for more information).

3