Loading the film

Use typical, 35mm color or B/W negative films with ISO 100, ISO 200, ISO 400 speed.

1.Slide the back cover latch (13) and open the back cover (21).

2.Insert the film cartridge into the film chamber (18).

3.Pull out about 50 mm ( 3 inches ) of the film from the cartridge and position the tip of the film above the take up spool until it reaches the ' film tip ' mark on the body, see figure 3.

4.Close the back cover.

5.Turn the mode dial to the ON position. Press the shutter release button (2) twice. The motor will advance the film and #1 will appear inside the exposure counter (15). The camera is now ready for taking the first picture.

Note:

If #1 does not appear inside the exposure window, then the film was probably not loaded correctly. Repeat the film-loading procedure.

TOO MUCH FILM LOADING

CORRECT