Acer TCO03 installation instructions Canadian DOC Notice, Preface, Important Safety Instructions

Page 4

NOTE

A shielded-type signal cord is required in order to meet the FCC emission limits and also to prevent interference to the radio and television reception. It is essential that only the supplied signal cord be used.

Canadian DOC Notice

This Class B digital apparatus meets all requirements of the Canadian Interference- Causing Equipment Regulations.

Cet appareil numerique de la classe B repecte toutes les exigences du Reglement sur le materiel brouilleur du Canada.

Preface

This manual is designed to assist users in setting up and using the LCD Monitor. Information in his document has been carefully checked for accuracy; however, no guarantee is given to the correctness of the contents. The information in this document is subject to change without notice. This document contains proprietary information protected by copyright. All rights are reserved. No part of this manual may be reproduced by any mechanical, electronic or other means, in any form, without prior written permission of the manufacturer.

Important Safety Instructions

1.To clean LCD Monitor screen;Power off LCD Monitor and unplug the AC Cord. Spray a non-solvent cleaning solution onto a rag and clean the screen gently.

2.Do not place the LCD Monitor near a window. Exposing the monitor to rain water, moisture or sunlight can severely damage it. ter, moisture or sunlight can severely damage it.

3.Do not apply pressure to the LCD screen. Excess pressure may cause permanent damage to the display.

4.Do not remove the cover or attempt to service this unit by yourself. Servicing of any nature should be performed by an authorized technician.

5.Operate LCD Monitor in a room with a room temperature of 5°C ~ 40°C (or 41°F ~

104°F).Operating the LCD Monitor outside this range could result in permanent damage.

6.If any of the following occurs, immediately unplug your monitor and call an authorized technician.

*Monitor to PC signal cable is frayed or damaged.

*Liquid spilled into LCD Monitor or the monitor has been exposed to rain.

*LCD Monitor or the case is damaged.

3

Image 4
Contents Table of Contents Congratulations IT Equipment Recycling Information IT Equipment Recycling InformationCanadian DOC Notice Important Safety InstructionsPreface Package Contents Adjusting the Viewing AngleConnecting the Devices Assembling the MonitorOperating Your Monitor OSD OptionsColor Temperature Brightness & ContrastTracking PositionAuto Configuration LanguageOSD Position InformationGeneral Specification RecallSignal Technical InformationTroubleshooting Standard Timing TableProblem Picture is unclear and unstable Problem There is no picture on LCD Monitor
Related manuals
Manual 12 pages 56.87 Kb