Pelco SWM4-W manual Installation, Mounting the Adapter Plate

Installation

The following parts are supplied:

1Adapter plate with locking screw

1Wall mount

28-32 x 0.75-inch screws

To install the SWM4-W wall mount:

1.Run 24 VAC power, video (coax or UTP), and camera control wiring to the mounting location. If you are using coax video, do not attach a BNC connector to the cable until step 5. Refer to Table D, Table E, and Table F in the installation manual for the Spectra Mini dome for wiring information.

2.Thread the 24 VAC power, video (coax or UTP), and control wiring through the large access hole in the adapter plate. Then attach the adapter plate to the mounting surface using either the top/bottom or left/right pair of mounting holes. (The top/bottom pair is shown in Figure 1.)

NOTE: If mounting to anything other than a junction box, select appropriate mounting hardware for the mounting surface.

Figure 1. Mounting the Adapter Plate