Jasco 45235 user manual Multi-Camera Operation, Auto Mode 2 Camera Operation

7

Multi-Camera Operation

This wireless surveillance system is designed to work with up to 2 cameras. Additional cameras are sold separately. IMPORTANT: When using more than one camera, each camera must be assigned to a specific channel using the channel selection switch located on the underside of the camera housing.

Select either 1 or 2 for each camera. Each camera must be assigned to a specific channel; both cameras cannot be on the same channel or the signals will cancel out. If using only one camera you can select either Ch 1 or Ch 2, whichever provides the best picture. The slide switch located on the rear of the Receiver must be set to reflect the channels in use.

1 2

CAMERA 1

Channel Setting

1 2

CAMERA 2

Channel Setting

			MONITOR
		Channel
		Selection
		switch
		–	+	–	+
			BEEP		TRIGGER
13.5V 1.2A	Audio Out	Video Out
		1 2 1/2		V-HOLD	BRIGHT	CONT
		CHANNEL

Auto Mode (2 Camera Operation)

To have the Monitor automatically switch between two active channels, first check the receiver is set