LENS FOCUS
After mounting the lens, you must focus your C10CH Series camera. Adjust both the back focus (on the camera) and the fine focus (on the lens).
NOTE: The back focus has already been adjusted using a standard CS mount lens. However, you might need to adjust it again to match the mounted lens.
1.Auto iris only: Cover the auto iris lens with a suitable neutral density (ND) filter. This opens the iris completely. For best results, use a ND3 filter.
BACK FOCUS 
LOCKING SCREW
1.5 MM ALLEN WRENCH
VARIFOCAL
LOCKING SCREW
LENS FOCUS
LOCKING SCREW
MANUAL IRIS
LOCKING SCREW
2.Manual iris only: Open the iris completely. The figure (right) shows
the manual iris, varifocal, and lens focus locking screws for a sample lens. Refer to your lens documentation for more information.
3.If automatic gain control (AGC) is set to OFF, set it to LOW or HIGH on the FUNCTION SETTINGS menu. AGC is set to LOW by default.
a.Display the FUNCTION SETTINGS menu.
b.Change AGC to either LOW or HIGH.
c.Select EXIT to save the AGC setting.
4.Aim the camera at the farthest object in the field of view. Make sure it is at least 6.5 ft (2 m) away.
5.Fixed focal length lens only:
a.Set the lens focal length to far (∞).
b.Adjust the back focus:
(1)Use a
(2)Turn the lens until the image is focused.
(3)Tighten the back focus locking screw clockwise.
WARNING: Do not overtighten the back focus locking screw because you may damage the camera.
(Back focus is a coarse adjustment. You will make the fine focus adjustment in the next step.)
c.Adjust the lens focus to achieve the best fine focus.