Installation
PARTS LIST
The DF8 shipping carton contains two boxes. Inspect each box to make sure all parts are present.
BACK BOX
1Back box
1Parts bag
1Flat washer
1Split lock washer
1Screw
1Thread compound
LOWER DOME
1Acrylic lower dome with trim ring
1Parts bag
1
1
1Loctite® threadlocker
BACK BOX
PENDANT MOUNT
NOTE: If installing outdoors, make sure the back box is properly sealed to keep moisture out.
1.Install the mount for the pendant dome. Refer to the instructions supplied with the mount.
2.Bring the wiring for the dome through the mount. Refer to Table A and Table B for wiring distances.
3.Loosen the nut that holds the tilt table assembly to the base of the back box. Move the tilt table assembly as necessary and bring the wiring into the dome.
4.Apply thread compound (supplied) to the threads on the back box and screw the back box into the mount.
Figure 1. Installing Pendant Mount and Back Box
5 |