2.Attach a conduit fitting (not supplied), safety chain bracket, and lock nut (not supplied). Install a safety chain/cable (not supplied) that will support up to 16 pounds (7.3 kg). Install one end of the safety chain/cable to the safety chain bracket and the other end to a support structure in the ceiling.
3.Prepare the wiring for camera and lens power; refer to Table A and Table B on page 8 for wiring distances. Pull the wiring into the back box through the conduit fitting.
4.Compress the spring clips on the back box and push it through the hole until the clips spring back. Tighten the screws until you hear a clicking noise.
ATTACH SAFETY CHAIN HERE |
NOT SUPPLIED |
NOT SUPPLIED |
CEILING |
NOT SUPPLIED |
CEILING |
Figure 2. Installing the Back Box
6 |