Installation Instructions | MC3820 and MC5720 Cameras |
|
|
| PRODUCT SAFETY |
•Ensure installation and servicing is carried out by qualified personnel.
•Isolate from the supply circuit before any servicing.
•Installation method and materials must be capable of supporting four times the total weight of the unit.
•Power supply cords must be connected as defined in national electrical codes of practice for Class 1 earth protected equipment.
•Low voltage cameras must be connected as defined in national electrical codes of practice for Class 2 protection of double or reinforced insulation.
•Safety critical components must only be replaced with recommended parts.
The maximum load on the rear
REGULATORY NOTICES
Federal Communications Commission Part 15 - Digital devices
This Device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1)this device may not cause harmful interference, and
(2)this device must accept any interference that may cause undesired operation.
CERTIFICATIONS
This product meets the requirements of the following standards:
Electromagnetic Compatibility
EN55022: 1995 limits and methods of measurement of radio disturbance characteristics of information technology
Comprising:
IEC
IEC
IEC
Safety
EN 60950: 1992 Safety of information technology equipment, including electrical business equipment
DECLARATIONS
The manufacturer declares that the equipment supplied with this manual is compliant with the EMC directive 89/336 EEC and the low voltage directive 73/23 EEC and CE marked accordingly.
Page3