Program Update Menu

Use this menu to load a newer version of software into your unit. This menu also shows the current version of software that is in your DVR.

NOTE: To perform this update, you will need a USB ﬂash drive (32 MB minimum and FAT or FAT32 format) and a PC to access the Pelco Internet web site (www.pelco.com).

1.Load the new version of software from the Pelco web site onto the USB ﬂash drive. Contact Pelco Technical Support at 1-800-289-9100 if you need assistance.

2.Refer to Figure 2. Once the new software is on the USB ﬂash drive, insert the USB ﬂash drive into the USB port on the DVR.

3.(Skip this step and step 4 if you are already in the Setup Menu.) Press and hold the Function button. The Function Key List appears. Keep holding the Function button.

FUNCTION KEY LIST

0 : Setup

1 : Camera 1 recording/stop

2 : Camera 2 recording/stop

3 : Camera 3 recording/stop

4 : Camera 4 recording/stop

5 : All the cameras recording

6 : All the cameras stop

: Alarm On : Alarm Off

4. Press and release the 0 button, and then release the Function button. Enter the password if requested. The Setup Menu appears.

SETUP MENU

Camera/Audio

All Resolution

Alarm Output

Time

Password

Program Update

Exit

Help: ON

5.Use the Search (<</>>) buttons to move around within the menu. Highlight Program Update and press the Play/Pause button to select. The Program Update screen appears unless one of the following conditions exists.

•If there is no update ﬁle in the USB ﬂash drive, the error message “File name error” appears and you will be returned to the Setup Menu.

•If the USB ﬂash drive is not inserted in the DVR, the error message “Device not found” appears and you will be returned to the Setup Menu.

The Program Update screen shows the current software version in the DVR and the new software version that will be updated from the USB ﬂash drive.

PROGRAM UPDATE

Current Version:

Next Version:

UpdateQuit

C617M-A 8/04