VistaQuest VQ350 quick start Power-ON/Off the Camera, Capturing Images, Flash Charging, Self-Timer

3. Power-ON/Off the Camera

Hold down the Power ON/OFF Button for 2 seconds to turn-on/off VQ350 immediately.

4. Capturing Images

Step 1: Turn On VQ350 by holding down the Power Button for two seconds.

Step 2: Press the Shutter Button to capture an image.

5. Flash Charging

Press Mode Button until “ So ” appears on the LCD display, then press the Shutter Button

within 3 seconds to start charging the flash. The lightening icon “ ” will blink continuously

until it is fully charged.

6. Self-Timer

If you would like to include yourself in the image you wish to capture, you may use

the self-timer feature to delay the camera by ten (10) seconds. Place the camera on a tripod or a flat, stable surface. Turn on the camera. Press the Mode Button until

the “ ” icon appears on the LCD display. Press the Shutter Button. The camera will beep as it counts down and will capture an image automatically after 10 seconds.

7. AVI Capture

You can capture motion-video clips using the AVI Capture feature. The image is stored in AVI format. The image counter increments by one after movie clips are stored. Video clips are captured at a resolution of 320 x 240. The movie-clip frame rate will be approximately six frames per second. Movie clips are silent. (No audio.) To use the AVI Capture mode follow these steps: