◆“AWC” Mode
Auto White Balance Control Mode. This mode performs more faster action than ATW mode without operating range. AWC operation is also performed in one push lock mode. while the button “3” on the side view is pressed, AWC action started and then the button is released, WB operation is locked to fit the present shooting scene.
◆One Push Lock Mode
In One push lock mode, white balance can be aligned by pressing “3” button. When this button is released, white balance is locked.
◆“MWB” Mode
Manual White Balance Mode.
This mode is used for manual adjustment of white balance.
This mode can be adjusted by pressing buttons.(Button“1”, “2” on SIDE VIEW)
21
6. “9” V-PHASE ( In the line lock mode, Adjustment V-Phase)
When you are using the line lock, the LL/INT switch has to be set to “LL” mode.
a. Line lock zero cross adjustment
;Zero cross point can be adjusted by pressing “1”(UP) and “2”(DOWN) buttons of the camera
☞Zero crossing point of shipment state can be initialized after pressing the UP button (Button“1”) during about 10 seconds .
b.Line lock
;If more than two cameras are used in one switching system, phase difference in AC power line can be occurred.
It is needed to adjust this phase difference for each camera.
☞If the cameras are connected to different AC lines, you can use the line lock adjustment potentiometer of the camera (adjustment of
22