EverFocus ENVS1600, ENVS800, ENVS3200 manual Quick Start Setup

ENVS800 / ENVS1600 / ENVS3200 Installation Manual

5.3 Quick Start Setup

This chapter describes the minimum installation steps to install IP-cameras for standard (continuous) recording.

Note: This quick start setup is based on the premise that all IP cameras in the system are installed in the same network and IP-address range as the NVR. The default IP - setting of the NVR is DHCP mode. If there is no DHCP host on the LAN, a static IP configuration must be assigned using Windows.

1.Register your camera license serial number(s) (Internet connection required; for alternate methods see Appendix 9 Online License Procedures.)

A. Open “License Manager” Tool. Click CONFIG -> License Manager

B. Select “On line” as Activate type.

C. Input the “SN (Serial number)”, and then click on “Activate” button.

D. Main Console will be restarted if activated successfully.

14 of 115