Installation

1.Remove the plastic dome cover.

2.Lossen the two screws of the supporting bracket to remove the camera body.

3.Use four screws to fix the camera base on the ceiling.

4.Put the camera body back to the supporting bracket, then tighten the two screws to fix the camera.

5.Connect the BNC connector of the camera to a color monitor, or other video device through a 75 ohm type coaxial cable with BNC female connector at cable extension.

6.Connect the 12VDC/24VAC regulated power source of the camera.

7.Connect the audio output connector of the camera (model High Resolution Dome A) to the audio in connector of the monitor.

NOTE: Be very careful not to scratch or damage the lens while making any kind of setting.