14 Selector switch (Details) |
1.SENS UP switch |
To set the max. value (upper limit value) of the |
operating gain in the auto gain control circuit, set this |
switch to ON position. In case the back lighting is too |
dark and the camera sensitivity is insufficient, set this |
switch to ON position. |
2. BLC (Back Light Control) switch |
In case the back lighting is too bright to view the |
5
4
3
2
1
ON OFF
1/100S
PUSH/ATW
INT/LL
BLC
SENS UP
main object clearly, set this switch to ON position. |
(This figure shows the setting
before shipment from our factory.)
3.INT/LL switch(Set at LL position from the factory)
a.INT. (internal) control switch
When the internal synchronization is used, set the switch to the INT side.
b.L.L. (Line-lock) control switch
Matching the vertical synchronization with the power frequency is called the
When two or more cameras are connected to a monitor TV through a video switcher, the vertical sync. phase can be locked with the power frequency, and a stable vertical sync. is obtained without being disturbed at the time of switching.
Use Down/up Buttons to adjust the vertical sync. phase.
4.PUSH/ATW switch
This is the switch to select the white balance PUSH/ATW.
PUSH: When the lighting from the source is constant, it is possible to fix the AW setting.
Place something white (paper, etc.) in front of the lens in a way that the whole screen may be covered, then push the AW PUSH switch. At this moment the setting is saved and retained even after the power is turned OFF.
ATW: The camera automatically adjusts the white balance as it continuously measures the color temperature of the lighting source.
5.1/100s
When this switch is turned ON, the shutter speed is set to 1/100 second. It is effective in reducing the light intensity.
Caution:
When this switch is turned ON, AES does not operate.
4