Fisher VDC-D2184VA White balance adjustment, Synchronization settings, Line phase adjustment

Page 10

SETTINGS

White balance adjustment

Normally the switch 7 (WB) is set to the down (ATW: auto white balance) position and the white balance is adjusted automatically. If a manual white balance adjustment is necessary, follow the steps below.

Set the switch 7 (WB) to the up (MANU: manual) position, then adjust the color.

Turn R (VR302) to set the red ratio and/or B (VR303) to set the blue ratio.

VR303 VR302

7B WB R

Synchronization settings

The default setting is internal synchronization (INT). You can change the power supply synchronization by moving switch 8 to the up (LL) position. Refer to “Line phase adjustment” for details.

Line phase adjustment

When using a camera switcher to connect 2 cameras or more to one monitor, there may be a vertical roll of the images when switched. In such a case, set as described below.

1Set the switch 8 (SYNC) to the up (LL) position.

2Switch the display on the monitor from camera 1 to camera 2. Adjust the PHASE volume on camera 2 until the vertical roll of the image stops.

If more than two cameras are used, please repeat this procedure for all the cameras.

VR322

PHASE8

CAUTION:

If the vertical roll cannot be corrected by setting the PHASE volume on camera 2, try setting the PHASE volume on camera 1. If it still cannot be corrected, please check that the polarity of the power cords of all connected devices is correct.

English 9

Image 10
Contents VDC-D1184VA VDC-D2184VA About this manualAccessories ContentsFeatures For the customers in Canada Information to UserPour la clientèle canadienne Precautions Following step differs only when installing the Model InstallationInstalling the Model VDC-D1184VA Coaxial cable type and maximum lengthDC 12 V connection AC 24 V connection ~ ~ GND Cable Power cable/day-night cableConnections REDSettings Table a switch 2 ~ 100 1000 2000 W color/black and white switch settingHigh speed electronic shutter setting ApertureBacklight compensation setting BL-C modeSynchronization settings White balance adjustmentLine phase adjustment Color image setting Manual color/black and white settingLens iris adjustment Black and white settingAdjusting the lens AdjustmentModel VDC-D2184VA Model VDC-D1184VA No picture on the monitor screen TroubleshootingMonitor output pin Picture is not clearSpecifications Exclusions