Elmo TNC4604 instruction manual Part Names and Functions, HOW to Connect

PART NAMES AND FUNCTIONS

All dimensions in mm (inch)

4

	1	3
		60 (2.4)
60 (2.4)		8	5
		90 (3.5)

2

7 6

1 Lens mount	+ DC12V
Mount a CS-mount lens.	-

2Camera mount

For mounting a camera on wall, housing, etc.	+	+
			AC24V
(1/4"-20UNC thread)

3Focusing dial

	For fine-adjustment of the lens back-focus.		1	2
4	IRIS terminal		+	-
5	Connect when an automatic iris lens is used.	7 Ground terminal
	VIDEO OUT terminal	Connect this to the ground wire of the
	Connect to a monitor TV, etc.
		power supply cord.
	(BNC connector)
		8 Camera control switches
6	AC power terminal
		Refer to "CAMERA CONTROLS" on

Connect this to the AC24V 60Hz or DC12V	page 4.
power supply.

HOW TO CONNECT

1.Before connection, make sure that power of all units are OFF and cords are unplugged.

2.Mount a lens onto the camera. Refer to "HOW TO USE" for usable lens.

3.Connect video terminal of the camera and the video input terminal of a monitor TV, etc. with a 75Ω coaxial cable.

4.Connect the power terminal of the camera to a power supply.

Caution: Installation should be made by a qualified service personnel and should conform to all local codes.

Lens, coaxial cable for video signal and power supply are not supplied with a camera.

- 2 -