Opening The Housing, Inserting Camera

Using the Fantasea FL-3 and FL-4 housing:

Opening The Housing:

1.Observe that the locking mechanism has 2 recessed spring tabs. Place the lower corner of the housing against your stomach and with 2 fingers, press these tabs together while your other hand frees the rounded housing latch by gently pulling upwards.

2.Next, release the flanged locking mechanism from the other half of the housing and the housings will part open.

Inserting Camera:

Since the Fantasea's FL-3 and FL-4was specifically designed for the Coolpix L2,3 and L4 digital cameras, insertion is a simple matter of placing the camera in the housing.

1.Make sure the camera lens is centered in the rounded port area and that the lens does not distort the round black rubber seat. The housing is designed to have the camera fit in place perfectly, but if you are not careful, it is possible to put it in at an improper angle and hence it will be impossible to get a good seal or easy closure of the housing.

2.After camera insertion, be sure that the extended camera lens does not catch or bend the black rubber seat on the inside of the lens port. It is vital that the lens does not disturb this rubber seat.

Notes:

1.It is recommended to make some camera settings prior to inserting into the housing. Please refer to the Coolpix owner's manual for menu options and personal preferences to choose from.

2.Take a few test shots: it is recommended to turn the camera "on" and program to "Flash Always" mode before inserting into housing and then take test shots to make sure all systems are working.