Nikon MEC-2-CB-D60-N105 manual Power switch in on position

3. Turn on the camera by rotating the switch at the top right of the camera.

Power switch in on position.

4. Pop up the built-in flash by pressing the small button on the left side of the camera top.

Flash Pop-up button.

5.Snap the input end of the lightguide (the 5/8” diameter stainless steel end) into the clip and slide it towards the flash to a ¼” gap.

The lightguide snaps into the Lightguide clip. Leave ¼” to ½” gap to flash head.

Use of Iris Camera – MEC-2-CB-D60-N105 4