Curtis VR245 manual Power on/off, Setup menu

Page 9

camera.

Push and release inserted card if you wish to remove or replace the card.

Turn your camcorder OFF before inserting / removing the SD Card.

- Note that the SD Card has a tiny LOCK switch on the side. Set the switch to un-LOCK position to be able to store recorded videos, still pictures on inserted SD Memory Card.

2.4 Power on/off

In power-off state, press and hold the power key to power on the camera. In power-on state, press the power key to power off the camera.

In power-on state, let the camera idle for 1 minutedefaultto power off the camera automatically.

In power-on state, when battery level is very low, the camera will turn off after several seconds. You must replace the batteries.

2.5 Setup menu

 

 

In power-off state, press and hold Shutter key

then press POWER key

turn on the

camera, until enter set day and time mode, then press the Left/Right key to move the cursor,

8

Image 9
Contents Page Contents Memory and storage Function Description GeneralOther notices Maintenance and careCPU System requirementsAppearance and Buttons Start to usePage Install battery Charge BatteryUse SD/MMC/SDHC card Setup menu Power on/offVideo record Change modePlayback videos or photos Hdmi output OutputDelete files Connect to PCDownload files from camera to PC Open USB port Application of Attached ArcSoft MediaImpression Introduction interface for software installationXvid codec Installation Page Install Mediainpression MediaImpression Installation and UsePage Run MediaImpression Page Page Page Function mode Product specifications Image sensorResolution ShutterHand Strap Standard accessories Installation CD USB extension cable