6 | USING THE STRAP |
LOADING THE FILM | 7 |
Attach the strap as shown.
LOADING AND CHECKING THE BATTERY
Use one 3 V lithium battery (CR2).
1 |
2 |
1.Slide the back cover release upward to open the back cover.
Do not touch the inside of the camera, especially the lens.
2.Insert the film cartridge until it clicks into position.
ISO400 film is recommended. If you are going to use
Incorrect |
1 |
2 |
1.While pressing the bottom of the battery compartment cover 1, lift it as indicated to open 2.
Make sure the lens barrier is closed before opening the battery compartment cover.
2.Insert the battery correctly 1.
Close the battery compartment cover 2.
A new battery lasts for about 10 rolls of film.
3.Slide the lens barrier as indicated 1 until it clicks. Check the battery power as noted on the LCD panel.
3 |
4 |
Correct |
3. Position the end of the film leader |
ahead of the line pointed to with the |
arrow (A), and align the edge of the |
perforated section (B) with (C). |
Make sure that the film is |
positioned correctly between the |
positioning guides (D). Then close |
the back cover until it clicks. Make |
sure the back cover release has |
returned to the lower position. |
The film automatically advances to |
the first frame. |
3 |
lights (turns off automatically).
blinks and other indicators are displayed normally.
blinks and other indicators go out.
Battery is OK. You can shoot.
Battery is low and will need to replace within the next few photos.
Battery is dead and must be replaced with a new one immediately.
4. Open the lens barrier until it clicks. |
Make sure the exposure counter on |
the LCD panel reads “ ”. |
If “ 
” blinks, reload the film.