Oregon Scientific ATC5K VI Camera Mounting Description, VII Camera Usage, Battery Installation

Note: Use caution when twisting; the clip may be sharp.

ATC5K_manual-US0710.qxd 8/18/08 5:40 PM Page 5

VI) Camera Mounting Description

Mounting the camera using the handlebar grip:

The camera can be mounted in a number of ways using the straps and the velcro patch provided. Please follow the methods of mounting as suggested below:

Fixing the position of the camera

a)With the base of the camera facing you, turn the clip clockwise to tighten its position.

b)With the base of the camera facing you, turn the clip

counter clockwise to loosen its position.

Mounting the camera onto a helmet using the silicon rubber strap:

1. Attach the rubberized patch to the bottom of the helmet mount grip. 2.+3. Thread the silicon rubber strap through the helmet grip.

1.Place the handlebar grip on the handlebar.

2.Add the screw and nut to hold the handlebar grip securely.

3.Slide the camera into the handlebar grip and make sure the handlebar grip is locked with the camera.

4.Adjust the angle of the camera.

Mounting the camera on a tripod or camera mount:

1.Attach the tripod mount to the bottom of the camera.

2.With the tripod mount on the camera, screw it onto the webcam stand.

3.Adjust the angle of the camera.

#1

#3

#2

#4

4. Mount the helmet grip to the helmet using the silicon rubber strap.

5. Slide the camera into the helmet mount grip.

6. Adjust the angle of the camera making sure it's secure.

7.If the camera seems loose when the helmet is moved use the velcro patches to secure it against the helmet.

8.To avoid damage to the camera, the mount lock at the base must be loosened before twisting the camera.

#1 #2 #3 #4 #5 #6

Mounting the camera using the velcro strap:

1. Attach the rubber patch to the bottom of the helmet grip.

2+3. Place the helmet grip on the helmet, and thread the velcro strap through the helmet grip.

4.Secure the velcro strap by fastening it through the helmet vents.

5.Slide the camera into the helmet mount grip, and adjust the angle of

the camera making sure it is secure.

	#1	#2
#3	#4	#5

5

VII) Camera Usage

Battery Installation

	Use Caution, the edge of the base clip may be sharp.
When opening the cover make sure the clip is in
the same direction as the lens. Observe the following		(1)
precautions when opening the end of the camera:
1.	Unlock the rear of the unit by squeezing the black
	release buttons whilst lifting the latch.
2.	Use a coin or screwdriver to turn the screw anti-
	clockwise to release the battery door.
3.	Insert 2 x AA alkaline batteries into the battery slot	(2)
	with the polarity in the direction as shown.

4.Close the battery slot door and ensure the screw is tight before closing and locking the latch.

Note: When the battery is low, the low battery icon will appear on the LCD screen. Please ensure you save your recording and then change the old batteries for new ones.(3)

Always upload video footage to your PC prior to replacing batteries to avoid memory loss

Note:

a)Do not mix old and new batteries together. Replace both batteries at the same time.

b)Remove the batteries if the camera is not going to be used for extended periods of time.

c)Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries. Only batteries of the same or equivalent type as recommended are to be used together.

d) Do not touch the flat cable at the back of the camera. 6