Connection to the flash system
This product has been designed exclusively for use with the OLYMPUS digital camera electronic flash system.
3Remove the protective | 1. Set the |
cap before connection. |
|
1
2 Remove the cover before connection.
2.Connect the connection cable to the connection cable ter- minal of the
3.Connect the other end of the connection cable to the ex- ternal power supply connector of the electronic flash.
Memo: After removing the protective cap from the electronic flash, store the cap in the protective cap storage position of the
Note
•When plugging or unplugging the connection cable, always hold the plug . Do not pull it by the cord.
Turning the flash system on
3 1
2
1.Set the
2.Set the electronic flash power switch to ON.
3.Check the status of the indicator lamp on the
Lamp Status | Operating Status |
|
|
Extinguished | Power OFF |
|
|
Green lighting | Normal operation |
|
|
Orange blinking | Charge request |
|
|
Red blinking | Error (Temperature error) |
|
|
•When using the HV- 1, keep it in the hard
case to protect the attached battery pack.
Memo: Always turn the
Note
•If the indicator lamp blinks in red while the battery pack is attached correctly as described in this manual, unplug the power cord from the wall outlet and contact Olympus.
18