Firmware Update Procedure for
STANDBY/ON INFO
TONE CONTROL | STRAIGHT |
STEP3 ENTER FIRMWARE UPDATE MODE Plug the AC power cable of the AV receiver.
Press and hold the [STRAIGHT] button on the front panel and keep it pressed while you press the [STANDBY/ON] button. Once the front panel displays "Advance Setup", release the [STRAIGHT] button. Then, press and hold the [INFO] button for about 3 seconds until front panel displays “CDDA Upgrader”. Now your AV receiver is ready for firmware update.
STEP4 START FIRMWARE UPDATE
Turn on the BD/DVD/CD player.
Load the Firmware Update CD (Audio CD) and press [PLAY] button on the BD/DVD/CD player.
“Found Header” will appear on the AV receiver for few seconds. Then, the firmware update starts.
“Found Header” appears within 10 seconds from starting update disc playback. In case display doesn’t change after 10 seconds, retry the update process again from the beginning or check requirements for the update disc and connection. See IN CASE OF ERROR for details.
While update is in progress,
DO NOT interrupt the AV receiver by pressing any buttons or switching off the power.
When completed, “Update Success”, “Please...” and “Power off!!” are displayed repeatedly. Turn off the power of AV receiver.
Stop the BD/DVD/CD player, remove update disc and power off.
Page.3 of 5