Yamaha RX-497 Connecting the banana plug, Unscrew the knob, Tighten the knob to secure the wire

1Remove approximately 10 mm (3/8 in) of insulation from the end of each speaker cable and twist the exposed wires of the cable together to prevent short circuits,

10 mm (3/8 in)i I _ _

Unscrew the knob.

Red: positive (+)

Black: negative (-)

Insert one bare wire into the hole in the side of each terminal.

Red: positive (+)

Black: negative (-)

4Tighten the knob to secure the wire.

Red: positive (+)

Black: negative (-)

•Connecting the banana plug

(U.S.A., Canada, Australia and General

models only)

First, tighten the knob and then insert the banana plug into

the end of the corresponding temfinal.

Banana plug

•One or two speaker sets can be connected to this unit. If you use only one speaker seL connect it to either the SPEAKERS A or B terlninals.

•Use speakers with the specified impedance shown on the rear panel of this unit.

•IMPEDANCE SELECTOR

[O'-IIHL'o/AR'

Do not slide the IMPEDAN(E SELECTOR switch while the power of this trait is turned on, as doing so may damage the trait.

Select the switch position (left or right) according to the

impedance	of the speakers in		your system.
Switch
position		Impedance level
	If you	use one	set (A or B), the impedance	of
	each speaker nmst be 8 _ or higher.
Right
	If you	use two	sets (A and B), the impedance
	of each speaker nmst be 16 _ or higher.
	If you	use one	set (A or B), the impedance	of
Left	each speaker nmst be 4 _ or higher.
	If you	use two	sets (A and B), the impedance
	of each speaker nmst be 8 _ or higher.

•The Canada model cannot use two speaker sets (A and B)

simultaneously when the IMPEDAN(E SELECTOR switch is slid to the right position.

•If this unit ±;ailsto turn on. the IMPEDANCE SELECTOR switch may not be fully slid to either position. If this is the case. slide the switch all the way to either position when the power supply to this unit is completely cut of£

11