Kodak M883 manual Picture quality problems

			Troubleshooting
	Status		Solution
	Slide Show does not		■ Adjust the camera Video Out setting to NTSC or PAL (see
	run on an external		page 32).
	video device		■ Make sure the external device settings are correct. (See the
			device’s user’s guide).
	Computer does not		■ Make sure the battery is charged and installed correctly (see
	communicate with		page 1).
	the camera		■ Turn on the camera.
			■ Make sure the USB cable model U-8 is connected to the camera
			and the computer (see page 45). (If using an EasyShare dock,
			check all cable connections. Make sure the camera is seated on
			the dock.)
			■ Make sure EasyShare software is installed (see page 44).
Picture quality problems
	Status	Solution
	Picture is not clear	■ To automatically set exposure and focus, press the Shutter button
			halfway. When the framing marks turn green, press the Shutter
			button completely down to take the picture.
		■ Clean the lens (see page 57).
		■ Make sure the camera is not in Macro mode if you are more than
			27.6 in. (70 cm) from your subject.
		■ Place the camera on a flat, steady surface or use a tripod (especially
			in high-zoom settings or in low light).
	Picture is too dark	■ Reposition the camera for more available light.
		■ Use Fill flash (see page 9) or change your position so light is not
			behind the subject.
		■ Move so that the distance between you and the subject is within the
			effective flash range. (See camera specifications starting on
			page 55.)
		■ To automatically set exposure and focus, press the Shutter button
			halfway. When the framing marks turn green, press the Shutter
			button completely down to take the picture.
www.kodak.com/go/support				51