4 iCAM4000 Installation
1.Remove the two security screws (use included security bit wrench) from the bottom of the iCAM
2.While gently pulling the cover upward on the back plate, pull forward.
3.Position the iCAM back plate on the desired wall near the secured door and mark the holes as the figure below illustrates. The recommended height from the floor to bottom of unit is 142cm (56”), however the installation height can be adjusted depending on average user height.
210
206.4
181.6
110
26.7
HOLE
HOLE
HOLE
HOLE
HOLE
HOLE | HOLE |
148.4 | 155 |
Dimensions and Screw Holes on the Rear Enclosure
68.5Wall
25 | 43.5 | 8 | 42.9 |
|
| ||
|
| 9 |
|
148.4
Rotation Part with Front Enclosure | Rear Enclosure |
Dimensions of iCAM4000 (mm unit)