Speco Technologies HTINTD8, HTINTD9, HTINTT5, CVC6246IHR, HTINTB9, HTINTD10 Arrow indicates CAM Title

☞ NOTE

■ When the V-REV or H-REV mode is enabled, the text on the screen does not flip.

■ If you increase the SHARPNESS level too high, the picture may become distorted or noise may appear.

◆ MONITOR : Please change the settings value of video appropriate to your monitor.

1)LCD : Please select this menu item when using a LCD monitor.

2)CRT : Please select this menu item when using a CRT monitor.

3)USER : Please use this menu item when using a monitor other than standard ones. You can change the gamma, PED level, and color gain in the sub menus.

◆CAM TITLE : If you enter a title, the title will appear on the monitor.

1) If the SPECIAL menu screen is displayed, use the Function Setup switch so that the

arrow indicates 'CAM TITLE'.			CAMERA TITLE SETUP
2)	Set it to 'ON' by using the Function Setup switch.
			A B C D E F G H I J K L M
3)	Press the Function Setup switch.
			N O P Q R S T U V W X Y Z
4)	Use the Function Setup switch to move to a		a b c d e f g h i j k l m
desired letter and select the letter by pressing			n o p q r s t u v w x y z
the Function Setup switch. Repeat this to enter		- . 0 1 2 3 4 5 6 7 8 9
multiple letters. You can enter up to 15 letters.			←→CLR	POS	END
5)	Enter a title, move the cursor to 'POS' and
			SHOP
press the Function Setup switch. The entered
title appears on the screen. Select the position
to display the title on the screen by using the
Function Setup switch and press the Function
Setup switch. When the position is determined,
select 'END' and press the Function Setup switch
to return to the SPECIAL menu.

☞ NOTE

■ When the CAM TITLE menu is ‘OFF’, no title will be displayed on the monitor screen even if you enter one.

■ Only English is available in this mode.

■ If you move the cursor to CLR and press the Function Setup switch, all the letters are deleted. To edit a letter, change the cursor to the bottom left arrow and press the Function Setup switch. Move the cursor over the letter to be edited, move the cursor to the letter to be inserted and then press the Function Setup switch.

◆ SYNC : In areas where the supply is at 60Hz(NTSC), 50Hz(PAL), you can synchronize the output phase of multiple cameras using the power synchronization function (Line-Lock) without using a synchronization signal generator.

14