Before Use
Power Supply
ªUsing the AC Adaptor
1 |
1Connect the DC Cable to the Palmcorder.
2Connect the DC Cable to the AC Adaptor.
3Connect the AC Cable to the AC Adaptor and the AC Jack.
≥The AC Cable’s outlet plug does not fit
entirely into the AC Adaptor jack. A gap will remain as shown 1.
≥Before connecting or disconnecting the power supply, set the [OFF/ON] Switch on the Palmcorder to [OFF] and make sure that [POWER] Lamp is not lit.
ªUsing the Battery
Before use, fully charge the Battery.
≥We recommend using a Panasonic Battery. ≥We cannot guarantee the quality of this
Palmcorder when batteries from other companies are used.
1Attach the Battery to the AC Adaptor and charge it.
≥Since the Battery will not be charged when the DC Cable is connected to the AC Adaptor, disconnect it from the AC Adaptor.
≥The [CHARGE] Lamp lights up, and charging starts.
≥When the [CHARGE] Lamp goes off, charging is completed.
≥When the battery is completely discharged, the [CHARGE] lamp blinks at first, but the battery is charged normally. When the temperature of the battery is too high or low, the [CHARGE] lamp blinks and the charging time becomes longer than usual.
2Attach the charged Battery to the Palmcorder.
Disconnecting the Power Source
Set the [OFF/ON] Switch (46) to [OFF] and, while pressing the [PUSH BATT] Button (51), slide the Battery or DC Cable upward to disconnect it.
PUSH (51)
BATT(46)
ON
≥For other notes concerning this item, see
Charging Time and Available Recording Time
1h30min. |
B2h15min. (1h50min.)
A | 2h45min. |
B4h30min. (3h40min.)
| A | 3h55min. |
B6h45min. (5h30min.)
ACharging Time
BMaximum Continuous Recording Time
≥“1h30min.” indicates 1 hour and 30 minutes. ≥Battery
≥The times shown in the table are approximate times. The numbers indicate the recording time when the Viewfinder is used. The numbers in parentheses indicate the recording time when the LCD Monitor is used. In actual use, the available recording time may be shorter.
≥The times shown in the table are for continuous recording at a temperature of 68oF (25oC) and humidity of 60%. If the Battery is charged at a higher or lower temperature, the charging time may be longer.
≥The available recording time becomes shorter if you use both of Viewfinder and LCD Monitor simultaneously when using the 0 Lux MagicPix function or rotating the LCD Monitor frontward to record yourself or setting [EVF ON/AUTO] to [ON].