| FOCUS | + |
|
| |
| + |
|
| CH |
|
BAT.RELEASE | BLANKSEAR |
|
|
|
F
F
O
Y
ALP
Power switch
+
| FOCUS |
| + |
BAT.RELEASE | BLANKSEARCH |
|
Connections & Setup
Turn off the camcorder
1.Set the Power switch to OFF.
2.Close the LCD monitor.
Powering the Camcorder
You can power your camcorder with a battery or AC power.
Charging the Battery
1.Set the Power switch to OFF.
2.Raise the viewfinder.
3.Slide the battery into the back of the camcorder. Make sure the arrow diagram on the battery points down so that the contacts on the battery and camcorder match.
Important: If the battery pack is attached in the wrong position, a malfunction may occur.
4.Plug the small end of the power supply into the DC IN jack on the camcorder and the other end into an AC outlet. (The CHARGE indicator blinks.)
5.When the CHARGE indicator stops blinking but stays on, charging is finished. Make sure the Power switch is set to OFF, then unplug the power supply from the AC outlet and from the camcorder.
Important: Before detaching the power source, make sure the camcorder’s power is turned off. Failure to do so can result in a camcorder malfunction.
Chapter 1 | 15 |