Audio Dubbing
The audio dub feature lets you record new audio (sound) on a previously recorded tape without erasing the original video (picture). The previous audio is erased and replaced with the new audio.
The audio dub feature increases your editing flexibility. Video segments can first be assembled and then a single narration or music background can be added.
The new audio can be added two different ways.
•You can speak into the camcorder’s
•You can connect an external sound system to the white AUDIO jack on the camcorder.
To Audio Dub
1.Press and hold the small button on CAMERA/OFF/VCR while sliding it to VCR.
2.If you are recording from a source connected to the white AUDIO jack on the side of the camcorder, place AV OUT/IN switch to IN.
3.Insert the tape you want to audio dub and use PLAY, F.FWD, and REW/REVIEW to locate a point on the tape a few seconds before you want to begin dubbing.
4.Press REC/PAUSE exactly where you want to begin dubbing. This will place the camcorder in play pause.
5.Press and hold AV DUB, and then
press PLAY. Release both buttons at
the same time. A. DUB 
will appear in the viewfinder when the camcorder
is ready to begin audio dubbing.
A.DUB
6.To begin dubbing, start the audio
source and press REC/PAUSE.
will disappear from the viewfinder while you are dubbing.
7.Press STOP/EJECT when you are finished dubbing.
Remember: Place the AV OUT/IN switch to OUT to record on the camcorder.
Notes: If you want to stop dubbing at a certain point on the tape, turn on memory stop, and set tape counter to “0000M” at the point where you want the dubbing to stop. The camcorder will stop dubbing automatically when it reaches “0000M.”
35