Solving computer problems
is not connected to an ac power source,
Solution:
The
With this risk in mind, you can enable the
1.Turn your computer off and then on again; then, while the message, “To interrupt normal startup, press the blue Access IBM button” is displayed at the lower left of the screen, press the Access IBM button. Rescue and Recovery screen opens.
2.Click Access BIOS. The System Restart Required window is displayed.
3.Click Yes. The computer restarts, and the BIOS Setup Utility menu appears.
4.With the cursor key, select Config; then press Enter. The Power submenu is displayed.
5.Select Timer Wake with Battery Operation by pressing Enter.
6.With the F5 or F6 key, select Enabled; then press Enter.
7.Press F10 and Enter to save this setting and exit this utility.
For information about the BIOS Setup Utility, see “BIOS Setup Utility” in Access IBM, your
Problem:
The Fn+F12 key combination does not cause the computer to enter hibernation mode.
Solution:
The computer cannot enter hibernation mode:
vIf you are using one of the IBM communication PC Cards. To enter hibernation mode, stop the communication program, and then remove the PC Card or disable the PC Card slot. Click the Safely Remove Hardware icon in the taskbar (for Windows XP) or the Unplug or Eject Hardware icon in the taskbar (for Windows 2000).
vIf the hibernation utility is not installed in Windows 98 or Windows NT. To install the hibernation utility, refer to “Installing device drivers” in the Access IBM, your
vIf the hibernation mode is not enabled. To enable it, do as follows:
For Windows 98:
1.Start the ThinkPad Configuration Program.
24ThinkPad® T40 Series Service and Troubleshooting Guide