Wyse Technology 022108 specification

4.Remove the top cover from the thin client by inserting the tip of a small Flat-Edge Screwdriver just inside the edge of the lock receptacle to make contact with the metal liner that lines the opening. Apply pressure inward and downward on the metal liner while pulling up on the plastic housing until it releases.

5.Carefully remove the existing module from the socket, noting where the connector of the module is located. Push the module locking clamps, swinging them outward, from each side of the module to unlock it for removal; remove the module.

6.Install the 512-MB RAM module, label facing down, into the location of the original module at the same angle, and then press module’s raised edge downward until it snaps in place.

Warning

The RAM module may be susceptible to damage by Electro-Static Discharge (ESD). All industry-standard cautions should be followed to avoid ESD.

7.Replace the top cover and attach the vertical foot.

8.Proceed to “Verifying the Thin Client’s Operation.”