TV-IP572W / TV-IP572WI

TRENDnet User’s Guide

Trigger By - Always

This option allows you to record constantly. If you select Always bear in mind that the Recording Type should be Video and that the source usually comes from Profiles 1, 2 or 4 under Source. Make sure the SD Card settings are setup to accommodate the huge storage space required for Always connections. Click Apply to complete the configuration.

Trigger By – Schedule

This option allows you to record according to the schedule you setup. If you select Schedule a calendar of the days of the week appear. Here you can select from each day’s checkbox which days you want to setup and you can create a start and end time. Click Apply to complete the configuration.

Trigger By – Motion

This option allows you to record according to the motion parameters you setup. If you select Motion, click theOnlyduring checkbox. Then a calendar of the days of the week appears. Here you can click one of the day’s checkboxes and you can create a start and end time. The Recording Type changes to pre-record or pre-event settings. This means

the camera will start recording before the allotted time schedule. These times can only be set in seconds. Click Apply to complete the configuration.

Recording Type

The two main sections here are Snapshot and Video. Snapshot takes a picture from your recorded data and only works with Profile 3. Video captures source data from Profiles 1, 2, and 4. and is configurable in Video/Audio settings.

Target - SD Card

These settings depend on the size of your SD card. The larger your SD card the more storage space you have to record data. Recording data can be recorded in increments of 1-6 minutes. Cyclic settings can also be checked.

Target - Samba Network Device

The Samba Network Device requires a NAS server or a linux server to operate. Under Server, enter the server address. Click the Anonymous radio button to allow anonymous users to send files to the Samba server. Then enter the Share Folder, Sub Folder (if needed) and enter the disk space needed.

If you click the Account radio button then enter a Username and Password. This will authenticate the user every time they log on to the samba server.