Getting Started Guide 7.0 27
| 3 | Pins extended through: |
| • Rack-mount flange |
| • Rail-mount flange |
| |
| | Pins not extended through: |
| | • Rack-mount flange |
| | • Rail-mount flange |
4 |
Server |
Rail-lock |
pin |
Side release |
latch |
Attach the front rail bracket to the rack:
Press the tab 2 away from the rail. Slide the front rack-bracket pins 1 away from the rail-mount flange3 until the front rail bracket stays open. Place the rack-mount flange 4between the front rack-bracket pins 1and the rail-mount flange3. Press the tab 2away from the rail. The pins snap forward and extend through the rack-mount flange and the rail-mount flange.
Attention: Make sure that the rail is securely clamped against the rack-mount flange.
Insert the server into the rack cabinet:
Align the server on the slide rails and push the server into the rack cabinet. If the rail-lock pins are extended out, pull the side release latches toward you, which lifts up the rail-lock pins. Push the server into the rack the remainder of the way.
Install the cable-management arm:
Insert the cable-management arm into the five slots in the rear of the server. When the cable-management arm is inside all five slots, slide the cable-management arm to the left by pulling the locking cam back, away from the server.
Connect the cables and secure the cable-management arm to the rack:
Pull the cable-management arm away from the server, and connect the cables to the server. Route the cables through the cable-management arm.
Move the cable-management arm toward the rail on the right side, and snap the latch onto the rail.
