Sea & Sea 860G manual Attaching the Wrist Strap

165 mm+-2

Getting Ready

Inserting or Removing a Memory Card

1. Power off the camera.

2. Open the Battery / Memory Card Cover.

3. Insert the memory card into the card slot and press it down until a click sound happens. (Please press the memory card again to get it out once a click sound happens.)

4. Close the Memory Card Cover.

Formatting a brand new memory card is strongly recommended for first use.

The image(s) can be stored either in built-in flash memory or in memorycard. When the memory card is inserted, the images willbe stored in the memory card rather than the built-in flash memory.On the other hand, the images will be stored in the built-in flashmemory when a memory card is not inserted.

Attaching the Wrist Strap

1 2 3

10

	Getting Ready
Basic Photography
1.	Press down the POWER Button to turn on the camera.
2.	Set the Mode button at Image Shooting Mode ( ) for still image, Image Stabilizing Helper ( ISH ) for image stabilizing,
	Movie Clip Mode ( ) for movie recording and Voice Recording Mode(	) for voice recording.

3.Use TELE/WIDE Button to zoom in and zoom out.

4.Press the shutter button half way to do the focusing and then press the shutter button fully down to capture an image.

5.The LED Indicator starts blinking right after the Shutter Button is released. Once the LED Indicator stops blinking, you are ready to take another shot.

Or you can press Playback Button ( ) to view the images or movie clips you just took.

					14
1	2	2	3	4	6M

100-0021

5 6

Blinking

122 mm+-2

122 mm+-2

11